Home > Harley Parts > Front End, Frame & Axle >

  New!  Licks Cycles - Fork Boot Covers - 35-39mm
Fork Boot Covers - For 35mm to 39mm Fork Tubes -By Licks Cycles


 
List Price: $39.95


Product Code: LCC-FORKBOOTS-39
Qty:

Description
 

Fork Boot Covers - For 35mm to 39mm Fork Tubes -By Licks Cycles

Add a real touch of old school to your ride with Lick's high quality fork boots.

Made from high quality durable rubber that will last for years. Fully collapsible & sufficiently stretchable. Fits all bikes with 35-39mm fork tubes.

Tech Note: The Licks Fork Boots require the fork tubes to be removed from the triple tree by loosening the clamps. Properly torque clamps after installation and inspect before riding.

Average Rating: 1 of 5 Total Reviews: 2 Write a review »

  0 of 0 people found the following review helpful:
 
Review from dan decker August 9, 2011
Reviewer: dan decker from DRACUT, MA  
I have had these since the beginning of this riding season and they are already junk!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Review from John Bass June 2, 2011
Reviewer: John Bass from San Diego, CA  
I put these on my STOCK 99 Sportster XLC, they wore out in TWO MONTHS!... Lick's replaced them with a second set and they also only lasted 2 months and wore out exactly the same way. Lick's said they would replace them again with some old stock boots when I returned the second set, I mailed a set back and I have never recieved the 3rd set. The failure was in the first pleat of the boot, they wore all the way through on both forks mounted on STOCK 39mm fork legs. I WOULD NOT RECOMMEND THESE TO ANYONE, THEY DO NOT LAST!!! In 5 months I went through 2 sets of these Fork Boot Covers. Lick's need to figure out what is wrong with this product!!!!

Response from Licks

John – we have been looking at the pictures you sent of the installed fork gaiters and are trying to figure out what's going on. If you take a set of the gaiters and compress them as far as they go naturally you end up with a distance of 1 5/8” from the top of the outer fork leg/slider to the bottom of the lower triple tree. If the forks are shortened to where the measurement is less than that when the fork is fully compression perhaps that could cause them to tear.

Certainly looking at the inside of the gaiter where it fits over the slider, it is clearly designed to fit the slider with the stock chrome cover removed.  According to your emails, the installation was done without the dust caps being removed.  Perhaps this could cause them to tear.

We have literally sold hundreds of these and only one or two have had a problem, both of which had extended tubes and customers were trying to stretch the gaiters to fit.  Perhaps it is something specific to your bike that is causing the problem, we are not certain.  

We looked into this after you sent us the first blown out set. Our manufacturer came to the same conclusion as us, if this was in fact a product defect, they would certainly have come back to us in a much greater volume than the few sets out of the hundreds already sold.  My partner has been running a set of these very fork boots on his personal bike since 2007 with no issue.  

Whatever the deal, we want to make sure you’re happy regardless of this unfortunate circumstance.  Therefore, we have gladly refunded the total purchase amount including shipping.   Sorry we could not come up with an iron clad explanation for the multiple tears, but it seems to be an isolated problem that is specific to your bike …Thank you  Licks

Was this review helpful to you?